POBCO Guide Rails
Tops, Rods & Rails
With S.S. Bottoms for added rigidity & welding. Available in Lube-Filled & Anti-Static UHMW & High Temp Plastics.
Custom Profiles our specialty in a variety of Plastic Materials. Send your Drawing
World's Largest Selection
1/2" Round | Round Top |
|
GRA-0808-SS See 1/2" Round *MOST SANITARY | Ultra-D UHMW GRU-100 Plus Oil-Filled UHMW GRP-100 Anti-Static Black UHMW GRSD-100 [Fits over 3/8" rod] |
GRA-ROUND |
All Plastic Rail |
Round Top |
Round Top with Rod |
||
![]() |
![]() |
![]() |
||
GRA-1008 | GRA-1008-SS | GRA-109SS | #GRA-109-SS Conveyor Bed Supports | Ultra-D UHMW GRU-100SS Plus Oil-Filled UHMW GRP-100SS Anti-Static Black UHMW GRSD-100SS |
*MOST SANITARY |
Convex Top |
Flat Top Rail FITS #60 ANSI ROLLER CHAIN |
||
Ultra-D GRA-109SSC*MOST SANITARY |
GRA-CONVEX | GRA-1008-SSF | GRA-FLAT |
Fits #60 ANSI Roller Chain |
*When Pobco Guide Rail with S.S. Bottoms are used as a wear strip, the plastic insert should be fastened to the metal sheath at the leading end of the rail. Using a sheet metal screw through the back of the sheath or a heavy wire pin from the sheath or a heavy wire pin from the side should be adequate. This will prevent the insert from sliding within the sheath in the event the chain accidently catches on a leading edge. This also allows for thermal expansion and contraction of the plastic insert. |
12 ft. Rods overlap with 10 & 20 ft plastic Guide Rails to reduce crevices and improve rigidity and alignment. |