POBCO Conveyor Rollers (Standard Selection)

Customize your roller with the POBCO Roller Specification Sheet. For commonly requested sizes and materials, please review the following selection. The roller sizes below can normally ship quickly from stock or with short lead times. Please inquire to confirm details.

"RPMN" Series-Light Duty

POBCO's "RPMN" series rollers are constructed with 1.90" diameter, schedule 40 White PVC pipe, Molded Nylon Roll End Bearings, and bored to support a 1/2" diameter shaft, pin or stub shaft. These are an excellent, low cost, general purpose roller, often used on sorting equipment. Overall length of roller is made .25" shorter than the between frame dimension.

"RPU" Series-Medium Duty

POBCO's "RPU" series rollers are constructed with 1.90" diameter, schedule 40 White PVC pipe, UHMW Roll End Bearings, hex adapter, and 7/16" Hex spring loaded shaft. These rollers are suitable for many general purpose applications, and with the stainless shafting, they are highly corrosive resistant. POBCO assumes a total of 1/4" clearance total between frames dimension (1/8" on both sides) as well as 1-3/4"additional shaft length (7/8" on both sides) beyond distance between frames, unless otherwise stated by customer.

"RPD" Series-Light Duty Gravity Roller

POBCO's "RPD" series rollers are constructed with 1.90" diameter, schedule 40 White PVC pipe, Molded Delrin Roll End Bearings, and 7/16" Hex spring loaded shaft. These rollers allow for easy installation in the side frame with spring loaded shaft. These rollers are suitable for many light duty gravity conveyor applications, and with stainless shafting, they are highly corrosive resistant. POBCO assumes a total of 1/4" clearance total between frames dimension (1/8" on both sides) as well as 1-3/4"additional shaft length (7/8" on both sides) beyond distance between frames, unless otherwise stated by customer